Product Description
Taper: B / Linear
Percent @ Half Turn: 50%
Resistance: 10K
Tolerance: +-20%
Power Rated: 1/4W
Shaft Type: Recessed Screw
Shaft Knurl: USA / Fine / 24 spline
Shaft Length FMS (from mounting surface): 1/4"
Bushing Thread: 3/8 x 32
Bushing Diameter: 3/8"
Bushing Length: 1/4"
Body Diameter: 15/16"
Lug Type: Solder
Mounting Hole: 7/16"
Other info: None.
Tech's notes: "This panel mount trimpot is used in many Fender® amplifiers."
Product Videos
Product Reviews
3 Reviews Hide Reviews Show Reviews
-
Great for amp bias trim adjustments
I really like that the adjustment is basically hidden, and the slot is fairly small. One reviewer stated "Do be aware that the screwdriver hole is "pass through", so make sure there is nothing that can cause a nasty short just behind the pot. When you put in a screwdriver to turn the pot it'll go as deep as you let it go." My small driver only goes about 3mm past the slot due to the bevel in the driver. So I am very pleased with the design and operation of this pot.
-
Nice
Does what it says on the tin. I do wish they had them in bigger values as well (I prefer using higher impedance when working without a bias tap on the PT, 10k reduces the range available but I make it work) Do be aware that the screwdriver hole is "pass through", so make sure there is nothing that can cause a nasty short just behind the pot. When you put in a screwdriver to turn the pot it'll go as deep as you let it go.
-
Chassis mount Bias Pot
Works great. Put into my Princeton clone. Be aware - it does not come with a nut and washer.