Product Description
WARNING: Do NOT over-tighten the strain relief screws. It is normal for them to stick out a bit. Those screws should only be snug against the wire to assist with strain relief, not screwed in all the way. Over-tightening them may destroy your cable.
SquarePlug SPS6-S is the shortest 1/4" stereo soldered plug with strain relief on the market today. It protrudes by only 23mm when plugged in and has an outer diameter of just under 14mm. The SPS6-S fits on any controller/patch bay/switching system/interface and features a unique 2-screw cable holding mechanism. The screws hold the cable in place, preventing any tension on the solder joints.
Tests have been carried out on a number of cables with soft to more harder outer jackets with excellent results. You can safely hold the cable and pull it from whatever socket it's plugged in with minimal risk of harming the cable or the solder joints.
The PERFECT plug for use in tight spaces!
Features:
- Ultra-small body
- Centered solder point for Tip, solder terminals for sleeve, and ground
- Built-in strain relief
- Main insulator is a high grade poly-carbonate (more durable and heat resistant than the plastic, nylon, or fiberglass used by other manufacturers)
- Insulation sheet provided to prevent shorts to the body
Tech's notes: "These require cable that is 5.0mm-6.4mm in diameter, like our 2-conductor cable. Some stereo cable may be larger, so be sure to double check the cable diameter you plan to use these with prior to purchasing."
Product Videos
Product Reviews
1 Review Hide Reviews Show Reviews
-
Continuity between Ring and sleeve.
I purchased 2 so I could use them as a patch cable between my switcher and my patchbay and both of them have continuity between the ring and sleeve. About 3ohms. This is no bueno as this will cause the amp circuit to not switch properly. I am wondering if this is intentionnal or a design flaw. NG Response: "Sounds like you've received a defective plug. Contact CUSTOMER SERVICE to inquire about warranty support."
