Generic

Chassis - Blackface Style, AB763, 22W Reverb Amp

Deluxe Reverb style Mid-60s blackface style chassis for the AB763 22W reverb amplifier. The 22W AB763 is a dual channel, mid-power amp with tone controls, an optical vibrato effect, and a spring...

Panel - Blackface Style, AA1164 Rear, 12W Reverb Amp

Princeton Reverb style Mid-60s blackface style rear panel for the AA1164 12W reverb amplifier. The AA1164 is a single channel, mid-power amp with tone controls, an all-tube vibrato effect, and a...

Panel - Blackface Style, AA1164 Front, 12W Reverb Amp

Princeton Reverb style Mid-60s blackface style front panel for the AA1164 12W reverb amplifier. The AA1164 is a single channel, mid-power amp with tone controls, an all-tube vibrato effect, and a...

Chassis - Blackface Style, AA1164, 12W Reverb Amp

Princeton Reverb style Mid-60s blackface style chassis for the AA1164 12W reverb amplifier. The AA1164 is a single channel, mid-power amp with tone controls, an all-tube vibrato effect, and a spring...

Eyelet Board - Reverb Main Board Set, for AA1164

Main fiberboard set including the eyelet board and bottom insulator for an AA1164 reverb amplifier build. This set is a recreation of the original boards found in the classic 12 watt AA1164 reverb...

Push-Push - B500K Split Shaft Pot (M8-0.75)

Please note: These are PUSH-PUSH switching pots.  You push it to engage the switch, then push it again to disengage it.  Do not confuse them with the other type.  If you pull on these,...

Push-Push - B250K Split Shaft Pot (M8-0.75)

Please note: These are PUSH-PUSH switching pots.  You push it to engage the switch, then push it again to disengage it.  Do not confuse them with the other type.  If you pull on these,...

Push-Push - A500K Split Shaft Pot (M8-0.75)

Please note: These are PUSH-PUSH switching pots.  You push it to engage the switch, then push it again to disengage it.  Do not confuse them with the other type.  If you pull on these,...

Push-Push - A250K Split Shaft Pot (M8-0.75)

Please note: These are PUSH-PUSH switching pots.  You push it to engage the switch, then push it again to disengage it.  Do not confuse them with the other type.  If you pull on these,...

Potentiometer Cleaning Cap - M8 Thread

Potentiometer cleaning caps for use with aerosol cleaners such as DeoxIT. This is a great tool for difficult to clean potentiometers such as those on hollow body guitars and certain amp chassis. The...

Potentiometer Cleaning Cap - M7 Thread

Potentiometer cleaning caps for use with aerosol cleaners such as DeoxIT. This is a great tool for difficult to clean potentiometers such as those on hollow body guitars and certain amp chassis. The...

Potentiometer Cleaning Cap - 3/8"x32 Thread

Potentiometer cleaning caps for use with aerosol cleaners such as DeoxIT. This is a great tool for difficult to clean potentiometers such as those on hollow body guitars and certain amp chassis. The...

5-pin 1/4" Jack - Stereo Switching

5-pin 1/4" Stereo Switching Jack.  Commonly used on pedals, active instruments, and some amplifiers. Sold individually.

Amp Jewel - Fender Style Purple (Dark Blue)

MADE IN USA Fender® style lamp jewels are used on countless amps from all kinds of manufacturers. Threading: 9/16 - 27 *Actual colour may differ than pictured.  Not all computer monitors...

PCB - Daughterboard for Wiring 3PDT Footswitches

The 3PDT PCB daughterboard (P-PC-3PDT-BOARD) is a small board designed to simplify the wiring of 3PDT footswitches in guitar pedals. All inputs and outputs are clearly labeled on the PCB, removing...

Vintage Style Handle - Tweed Style Black

Replacement handle with the little bump in the middle for tweed style Fender® amps (6.5" from mounting center to mounter center). Sold individually.  Includes mounting spikes and screws.

Washer - Flat, Plastic, Black, For Cliff-style Jacks (7/16")

Aftermarket flat plastic washer for Cliff-style S2 and S4 type switching jacks. 7/16" (11.2mm) inner diameter, 5/8" (16mm) outer diameter, 1/16" (1.5mm) thick. Sold individually.  Bulk...

Pickguard - Esquire 8-Hole (choose colour)

These should be a good fit on MOST genuine vintage-style Fender® MIA and MIM Esquires®/Telecasters® with 8-hole pickguards.  We say "most" because there are quite literally thousands...

Pickguard - Esquire 5-Hole, 50's Style (choose colour)

These should be a good fit on MOST genuine vintage-style Fender® MIA and MIM Esquires®/Telecasters® with 5-hole pickguards.  We say "most" because there are quite literally thousands...

Generic PCB Socket Jack - 9-pin, Short, Stereo Switching

9-pin PCB socket jack.  Insulated, switching tip, ring, and sleeve lugs. Withstand Voltage: 50VDC Min. Maximum Current: 1A Temperature Rating: -25°C ~...